Brand: Met Craft
Product Code: MCAH-011-0-3DS
Name: Soft Closing Hinges SS Hydraulic Clip On 3D
Crank: Full Overlay 0 Crank
Material: Stainless Steel
Open Degree: 90.
Height of Hinge Cup: 11.3 mm
Diameter of hinge cup: 26 mm.
Distance from door edge to the cup(K): 3-5 mm.
Recommended door Thickness: 14-22mm.
Installation Technological information.
Full Overlay.
The door is in front of the cabinet wall and only an small gap remains at the side within which the door can open relaibly,Alternatively. the door can also be overlay fully. in which case sufficient space must be allowed at the side for the required minimum reveal. Straight hinges are used. Half overlay.
This is where two door are positioned in front of a cabinet centre panel.the required overall reveal is between them(at least 2x Maximum reveal). In other words each door has a smaller overlay and cranked hinges are therefore used.
Inset.
The door is positioned inside the cabinet i.e next to the cabinet side here too a gap is needed so that the door can open reliably Highly cranked hinges are used here for an inset door the holes for attaching the mounting plated must be offset to the rear Position of the fixing holes = 37 mm + door thickness + 1.5 mm + door offset.